Chapter 60 High-temperature ultrasonic vibrating knife!
Author: Charcoal grilled bamboo shoots
Chapter 60 High-temperature ultrasonic vibrating knife!
Half an hour later.
A security guard knocked on the door.
A piece of pork belly was sent over and was inspected and confirmed to be fine.
Chen Yi hung the pork belly with its back to a steel plate.
Avoid laser penetration later, stray bullets, oh no, stray light causing accidental injury.
Hang up the pork and pick up the laser gun.
Chen Yi found the gear switch.
Lowest level test.
Bah!
A ray of light flashed.
The faint smell of burnt pork slices wafted up.
I saw a burnt spot with a diameter of 2 cm on the surface of the pork belly.
But it was superficial and did not go deep.
"It's really tattoo removal."
Chen checked it and adjusted the power to the second gear.
Bah! A brighter light flashed.
There was a 3cm burnt mark on the pork belly.
In the center, an area of ​​about one centimeter in diameter, the pork skin has completely turned into black char.
Chen Yi took out a knife and scraped away the layer of coke.
The depth went in more than 1 centimeter.
"If the second gear hits, the dermal layer will be scorched.
This kind of attack might not be fatal with a few more shots.
But the pain involved is definitely difficult for ordinary people to bear.”
Chen Yi was amazed and continued the third gear test.
Bah!
Light flashed.
The smell of burnt meat and barbecue broke out all of a sudden.
The pork belly had a large thawed area.
In the center of the thawed area, an area of ​​more than two centimeters was completely charred.
Chen Yi scraped away the scorched area and found that the bottom 3 centimeters were completely scorched black.
All the way down to a depth of about 8 centimeters, the pork is already cooked.
The pork meat with a circumference of more than 12 cm will be hot.
"If the power of the third gear hits the torso and head, it will definitely be fatal.
And it's not like an attack where a gun goes in here and comes out of a big hole, killing you on the spot.
Such a large piece of body and internal organs are so ripe that it will take at least a while of howling in pain before it dies. If it is sent to the hospital in time, it may last for three days and three nights."
Chen Yi mentally estimated the damage, with a hint of wonder in his eyes.
He did not forget that the pork being tested was a large piece of frozen, hard pork.
If it were a human body with a body temperature of 36.5, the damage would be even more terrifying.
"Highest gear, fourth gear."
Chen Yi adjusted the laser to the fourth gear, aimed, and fired.
Bang! Boom!
The light shines.
The pork in front of you exploded in an instant, exuding a warm smell.
The steel plate behind the pork also showed signs of being burned at high temperatures, melting and reddening.
"Such lethality and multi-level control functions are completely sufficient to deal with criminals."
The test determined the attack parameters of the laser gun.
Chen Yi clicked on the interface and chose to read the laser gun information.
A lot of information emerged in Chen Yi's mind.
Because I have just read the laser power information, I already have a preliminary understanding of the laser.
In less than twenty minutes this time, Chen Yi absorbed and understood all the information.
"Top optical technology, efficient light source conversion technology.
I'm afraid only companies that manufacture photolithography machines can create this, and the cost will be at least tens of millions."
Chen Yi frowned and thought for a while: "The manufacturing field of semiconductors and optics.
The technology is one level lower, and the cost and cost are the difference between heaven and earth.
If we replace it with inferior technology, reduce the accuracy of the laser gun, and reduce the actual attack power and efficiency of the laser gun.
In this way, ordinary companies that manufacture microscopes can assemble and produce them, and the cost can be reduced to less than 20,000.
After reducing the technology, the attack and efficiency of the laser gun are still about 89% of the original.
In addition, the efficiency is reduced and the heat generated by laser emission will be high.
If you fire two shots in 4th gear or seven shots in 3rd gear, the laser gun needs to cool down for 5 minutes to avoid high temperature overload."
"This kind of performance is completely sufficient for the police!"
"After all, we are just arresting criminals, not going to the battlefield."
"Realistic firearms also require changing magazines."
Chen Yi made some calculations in his mind and decided simply to lower the standard of this laser gun.
These police drone orders must be mass-produced through industry.
It is impossible for him to produce them one by one by hand.
If the standards are not lowered, the cost will be tens of millions.
It is simply unrealistic to find a photolithography machine company for production.
"The next step is to use drones as a critical weapon."
After deciding on the laser gun plan, Chen Yi thought for a while, took out his notebook and wrote down two terms.
[Ultrasound + shock wave.]
"Perhaps, we can add this."
Chen Yi pondered for a moment, then added the word microwave after shock wave to form an equation.
Ultrasound + shock wave + microwave = high temperature ultrasonic oscillation knife!
Ultrasonic vibrator!
This is the technical solution that Chen Yi has always wanted to test and turn his drone into a super sharp blade.
Chen Yi is no stranger to shock waves.
Whether it is aircraft design or aerodynamic layout, there are a series of parameters related to shock waves.
It was the last time that a white-faced salesman was captured in the land, wind and sea, and the drone was controlled to cut the cable, but the drone was not damaged.
Or the scalpel over the Barents Sea more than thirty years ago.
The Big Brother pilot used the vertical tail of the Type 27 fighter to cut the engine of the Lowe P-3B fighter.
The engine of the P-3B fighter jet was scrapped and it almost crashed on the spot. However, the tail of the fighter was only slightly damaged.
Everything is proved.
Once the aircraft breaks the sound barrier and exceeds the speed of sound.
Then, in front of the fuselage, there is a layer of shock waves attached to the surface of the fuselage, which has powerful energy and cutting capabilities.
This energy, if used wisely.
It might be possible to turn decay into magic and make drones a sharp blade for attacking difficulties.
According to this idea.
Chen Yi integrated the idea of ​​ultrasonic cutting on the basis of shock waves.
In reality, those seemingly inconspicuous ultrasonic cutting knives can easily cut through some hard plastic and metal sheets.
If shock waves and ultrasonic cutting can be combined, shock waves can be used as the "blade" of the drone.
Then use ultrasonic vibration to enhance the power of this "blade".
One can cut and penetrate metal steel plates, crush and penetrate concrete, and penetrate various obstacles.
And drones with almost no damage themselves may be born as a result.
If you go further.
Through microwave heating, an ultra-high temperature buff is added to this "blade".
Based on the ultrasonic oscillation knife, it is upgraded to a high-temperature ultrasonic oscillation knife.
Well, even high-strength steel.
In front of this drone, I'm afraid it's not much different from tofu.
Once successful, such a drone will definitely be a nightmare for ground armor.
"Shock waves will naturally occur when flying at supersonic speeds.
In this way, only the aerodynamic layout of the aircraft needs to be improved to achieve the concentration of shock wave energy.
Ultrasonic transducers are relatively simple, and their core is nothing more than piezoelectric ceramics.
The real problem is the microwave heating module.
I don't have a shock generator capable of heating the air.
Neither the laboratory nor Yifei have the production equipment for this kind of thing."
Chen Yi frowned slightly.
Microwave generators are quite common.
There are several microwave ovens upstairs and downstairs. You can use them by removing the generator inside.
But the frequency of this microwave oven generator only works on the water molecules of the object.
There is no generator on the market that works on air molecules or ions.
Perhaps system adjustments and upgrades can lead to corresponding technology upgrades.
However, the laboratory does not have production equipment, and if we have the technology, we can only find manufacturers to customize it.
As time goes by, the cost of time goes up.
"Microwave generator that oscillates heated air and ions"
"The most awesome thing is probably the tokamak, the microwave generator used in nuclear fusion devices, right?"
"I remember, this is what ignites the nuclear fusion reaction."
Chen Yi thought for a while.
If you decide to be undecided, you will waver.
According to his level of confidentiality, it shouldn't be difficult to buy a second-hand obsolete nuclear fusion ignition device.
The domestic EAST tokamak device has achieved thousand-second operation at 160 million degrees Celsius.
When he buys a second-hand item, his requirements don’t have to be so high.
Cut it in half, cut it in half, cut it in half again, and you’ll be satisfied if you can have a temperature of 20 million.
If it doesn't work, cut it a few more times.
The temperature can be several million degrees Celsius, which is acceptable.
Thinking of this, Chen Yi did not hesitate, took out his mobile phone and dialed Professor Zhang's number.
Chapter completed!